The LRIG Discussion Mail List is for comments or questions about Laboratory Robotics and Automation. You will receive messages posted to the list and you will be able to post and reply to messages.
The members list is private and is not accessible by anyone other than the moderator. This mail list is moderated. SPAM, flames, or inappropriate messages will be filtered out before they are sent to you. Our vision at LRIG for this mail list is that it should be a dynamic forum for users and vendors to freely exchange ideas and solve problems. We want to be sure that the demeanor of the mail list reflects the desires of the subscribers. The majority of the subscribers have indicated that they do not want to receive unsolicited sales or promotional messages in this forum. However, it is entirely appropriate and welcomed that vendors reply publicly to an inquiry posted to the list.
A couple of comments on posting etiquette:
1) When you reply to a message trim the original message down to just the portion you are replying to (if possible). The aim is to reduce the clutter for the list members while preserving the sense of the message.
2) It's nice to say "thanks" to respondents who helped you out, but do it directly to them and not to the whole list.
3) The same applies for individualized messages that do not add value or knowledge to the discussion.
4) Be aware that when you reply to a message, the default is that it goes to the whole group. If your message is personal, be sure it is addressed only to the intended party.
5) Please do not post a message with "Return Receipt Requested". This violates our privacy policy.
If you are not a member of the Laboratory Robotics Interest Group, a registration form may be found at:
http://lab-robotics.org/member_registration.htm
Andy Zaayenga
Moderator, The LRIG Discussion Mail List
Has anyone used, or does anyone know, where I might be able to find slightly wider-bore tips for use on the Biomek FX 384-channel head (similar to the Beckman
Does anybody so something similar? I found the most I could dispense was 2-3uL, otherwise the drop was too big and flooded the top of the plate. I could
The Laboratory Robotics Interest Group Discussion Group is for comments or questions about Laboratory Robotics and Automation. You receive messages posted to
We use Brady labels (bradyid.com). What I like about their product is the variety of label media available and the pre-designed templates in the Bradysoft